PLEASE WAIT AS CLIPS MAY TAKE SOME TIME TO DOWNLOAD....
EXAMINER TELLS YOU WHEN IT'S ONTO A TARGET
Clip 1. Basically red positive electrode from multimeter to base of handle, black negative to antenna tip (left). Without swinging or allowing detection the unit is turned a full 360 degrees showing no change in reading (right).
Clip 2. The same only this time with the gold frequency entered . Note now the numbers are increasing whereas no swing = no reading in millivolt change. There are three known gold deposit directions and the Examiner is detecting all three in this clip.
.
Clip 3. In order to prove that there is no increase just because the antenna is turning the unit is moved around like it is detecting a direction. There is no difference in readings.
Clip 4. Where there is zero (0.00) on turning the Examiner 360 degrees it is determined by the Examiner that in this direction there has never been any gold detected.
CONCLUSION: There is a visible difference in the millivoltage readings when the Examiner is detecting gold but not before. When the Examiner is set to detect an area of no gold this occurs exactly in the direction the 0.00 was noted.
RTL&ES in association with maxFynd
The Rangertell Examiner - 2007
The above experiment and the results posted are copyright and remain the property of Rangertell and any alteration or improprietous use is prohibited . Permission of Rangertell and the conducting scientist required. BVTEL04