Your body is a major component in the use of these instruments. It literally becomes part of the receiving component due to that fact that your body has an electrical charge which in turn emits an electromagnetic field or flux around it . 
Your body is a major component in the use of these instruments. It literally becomes part of the receiving component due to that fact that your body has an electrical charge which in turn emits an electromagnetic field or flux around it .
The polarities around the body were determined by R-T using an Examiner tuned to the body frequency (between 6 and 7Hz) and touching the body, observing the swing. Any user can verify this for him/herself. The minus key will give an attraction to the body if the field there is positive and vice-versa. The diagram also shows why you get a better lock walking past the target. The field extends further and there is no gap in fields as can be seen at a 45 degree angle from the body.
This field is emitted at 6-7 Hz and acts as a carrier when a signal-line is formed between your locator and the element you’ve tuned to. The element itself has it’s own electromagnetic signature due to having an an electrical charge, even though minute. This system operates in a similar way to a radio transmitter and receiver. The transmitter transmits an omnidirectional electromagnetic wave or signal .When a radio is turned on this electromagnetic wave is drawn into it via the antenna and forms a signal line from transmitter and receiver.
EXPERIMENT: Take your Examiner or LRL and set it to the frequency of your local radio or TV station. Walk between the radio or TV receiver and the direction of the aerial, usually on a hill in your district. Doing this without knowing where it is will be a good blind test. You may find there is a carrier aerial on another hill as well as the main one, thus giving you another signal-line. The antenna will swing as you cross the signal-line. The electromagnetic signal from the radio or TV transmitter forms a signal-line in the same way one is formed between your LRL and the target.
...
An experiment was carried out by an English Lord many years ago. When asked whether electrical energy flowed form (+) to (-) or (–) to (+), he determined that electrical energy flowed both ways. See Diag 2. The only difference was the polarity. The signal between you, your LRL and the target is the same. It is thus not such a one-way street. For the purposes of mathematics one assumes the uni-directional current law has been adopted without much fare given to the truth ie. that is more of a give and take system flowing both ways. Whenever there is a flow of electrons, there is an electromagnetic field. The difficulty lies in measuring this when you get down to raw micro-field level.
...
Solar energy has a positive charge (+) which spirals down in a clockwise direction. Earth has a negative charge (-) and is emitted in an anti-clockwise direction. The confluence of charges creates a perfect charge potential for the LRL to use as a ‘sounding-board.’ See Diag 3.
All these factors work with LRLs, MFDs and metal detectors. It amazes us how the skeptic forgets to tell you this information because most haven’t the foggiest idea about electromagnetic wave or signal propagation and their relationships and interactions with one another. For example the MRI (Magnetic Resonance Imaging) used in the medical industry picks up electromagnetic fields from your body using an electromagnetic field produced by the MRI equipment . There is no wiring there. Putting a crystal under pressure allows a stronger piezoelectric magnetic field to form. Simple pressure will increase the sensitivity. No wiring there. Measure the charge with an Examiner or positively charged rod and you will see that the charge's polarity has been switched. All matter interacts with itself to form these magnetic fields. There is no wiring between a standard metal detector and the target. The beat may be out but it’s still the frequency or resonance energy being compared with itself. Your computer is composed of a hard drive, floppy and pc board mainly. The hard drive has an actuator arm inside that moves above the disk on a cushion of air . There is no connection or wiring there. It seeks the positive or negative charges imprinted on the disk. A set of these forms a byte. The same with the floppy disk or the CD. There is no direct connection between the receiver and processor, just air. Case in point the aerial wire you see protruding from the Examiner control box does not need to be in contact with the calculator for the inductance to be conveyed across a layer of air. There is no power supply in a crystal set. The tuning circuit crystal is using the resonance parameters ot the signal without requiring batteries. The tuning circuit in the Examiner is using a specific frequency, that of the target to tune in, using the resonance parameters of the target.
NOTE: The Examiner T-G is completely safe since it works with tiny currents. If you walk in front of a TV you will note the effect of your body on the picture depending on how far the set is out of tune. So too the Examiner reacts to electromagnetic fields. The TV field would be millions of times stronger than the Examiner. Over 1000 RT units sold there has been no evidence to suggest any effect on the user. It is not a dowsing instrument per se so using it as one, may drain in the same way any dowsing instrument can. Even a bent straw can respond in the hands of a dowser so do not imagine it is the same idea based on the L shape. A dowser by definition is not allowing the instrument to respond to the frequency alone but using his mind and body to come to what is considered by the skeptics an unscientific estimation.
THE EXAMINER IS AN ELECTROMAGNETIC ENTITY WHOSE VALUES VARY WITHIN THE FIELD
Bar magnet showing fields
Diag. 4
The above can be illustrated by moving towards the North Pole and noting the Examiner swinging away as like charges repel.
Once the frequency is entered the sine wave tells the circuit that the gold or target sought is at a point on the sin wave . Put another way the target is say North 5 degrees 16 minutes 0.03 seconds. The antenna aligns with this direction according to the laws of physics seeking linearity within the wave parameters.
There are other accepted methods of electromagnetic transference that forms the basis of our world today. Those who are perplexed are not necessarily technically-challenged. They simply haven’t been told the facts. Take a look at a transformer or electric motor. There is no connection between the revolving shaft component and the curved magnets on either side in an electric motor. Just an air-gap. In a transformer no connection
between the primary and secondary coils. Induction allows the passage of electromagnetic energy. So too the Examiner needs no direct connection.
Living under high tension lines has an effect on your body . It’s a reasonably accepted fact. Why? The electromagnetic field given off affects your body countering the electromagnetic field your body produces. The same process works between the calculator and inductance coil and circuit in the Examiner. The circuit resonance is set to your body’s electromagnetic field resonance which gives you your carrier wave. The electromagnetic oscillation frequency wave you’ve set in the calculator is imposed on the carrier wave. Radio transmission people are familiar with this process.
Here you will see more examples of how successful the Rangertell concept is.
Ranger/Tell
..........